Among the many re-finish jobs on the Dino, the wheels require special attention. They are made of an aluminum/magnesium alloy that corrodes if not treated properly. To this end a very laborious process is required to get them ready for paint. The process is as follows:
1. Remove old tires, tire stems, and wheel weights from rims
2. Thoroughly wash wheels and inspect for any damage
3. Chemically strip wheels. We use Goudeys paint stripper as profiled in previous threads
4. Wash the wheels again
5. Once dried touch up any missed spots in the blast cabinet using medium pressure and gentle media
6. Wash the wheels again
7. Apply Alodine solution as per directions to treat the wheels for paint.
8. Wash the wheels again
As you can see there are a lot of steps before any primer or paint goes on. This process was introduced to us by Steve Kouracos and is profiled in the following link on his website:
We thank Steve for sharing this information with us and look forward to the priming and painting steps.